When your garage roller door breaks down, calling a maintenance specialist to fix it can be costly. If you want to get it fixed without the hefty fees, you can choose to do it yourself. There are two primary components of a garage door: the door itself and the opener. In this article, we’re going to teach you how to do di garage roller door repairs Adelaide and avoid costly fees. We’ll start with the actual door before moving on to the rest of the parts.


Repairing a Garage Door

Most garage doors are overhead. Whether they function by rolling up in sections or swing up in one piece, they all operate on spring tension. Every roller door moves on metal tracks attached on the garage walls, with a heavy spring or springs providing the power. In a lot of cases, when the door doesn’t work or gets stuck, the repairs are relatively simple. Here are some helpful step-by-step tips that you should keep in mind:


Step 1: Check the Metal Tracks Inside the Garage

Look at the mounting brackets and hold them to the wall. If they’re loose, tighten the screws or bolts at the brackets. While working inside the garage with the garage door closed, examine the tracks for potential drips, dents, or flat spots. If there are any damaged spots, pound them using a rubber mallet, or with a standard hammer or a block of scrap wood. If the tracks are visibly damaged, they should be replaced right away.


Step 2: Make Sure Tracks are Aligned

The next thing you need to determine is whether or not the tracks are aligned. You can do this by using a level. Horizontal tracks should slant slightly down towards the back of your garage;  with roller door repairs Adelaide, the vertical sections of the tracks should be exactly plumb. The two tracks must be at the same height on the garage walls. If the tracks aren’t correctly aligned, loosen, but not altogether remove, the bolts or screws that hold the mounting brackets. Once they’re misaligned, tap to position them back again carefully. Re-check the tracks with your level to make sure they’re now in the right position before tightening the screws or bolts at the mounting brackets.



To access the full version of this article, click this link here now and download the whole article in PDF form for more comfortable reading.